1、升降機廠家介紹升降機運行期間，檢修運行人員要經常檢查泵站、電機各部位有無異音，經常檢查泵在運行狀態下的震動情況，保證泵的平穩運行。
Lift manufacturers introduced during lift operation, maintenance personnel should always check the pump station is running, there is no different from all parts of the motor sound, always check the pump in the running state of shock cases, to ensure the smooth operation of the pump.

2、升降機廠家建議運行人員要定期檢查軸承的潤滑狀態，油量油位是否正常，甩油環隨泵轉動是否靈活，隨時能夠保證軸承得到充分潤滑。
Lift manufacturer recommends operating personnel to regularly check the bearing lubrication, fuel oil level is normal, slinger with the pump rotation is flexible, ready to be fully able to guarantee bearing lubrication.

3、升降機廠家提醒油路是否正常，軸承溫度是否在規定溫度下，還要注意電流、壓力是否正常，軸承溫度是否在規定溫度下，還要注意電流、壓力是否正常，保證升降機各部位緊固螺絲有無松動現象，觀察承載箱體有無漏油、進水現象。
Lift manufacturers remind the oil is normal, bearing temperature is at a predetermined temperature, but also pay attention to current, pressure is normal, bearing temperature is at a predetermined temperature, but also pay attention to current, pressure is normal, to ensure that all parts of the fastening screws have lift no loosening, observe whether the bearing box oil spills, water phenomenon.

4、升降機廠家介紹平時泵站運行方式采用兩用一備方式進行切換運行，備運泵在停運后運行人員應立即關閉泵的出入口門，然后再關閉備用泵的軸封水門，保證泵的腔體內始終存在清水，以防灰水進入泵腔體內沉積造成泵體葉輪和付葉輪被積灰堵塞而造成下次啟動燒馬達故障。
Manufacturers usually lift pump station operation mode introduces a standby mode using dual switch operation for shipment after the outage run pump should immediately turn off the pump entrance door, and then close the door spare pump seal water, to ensure the pump cavity there is always water, gray water into the body to prevent the deposition chamber causing the pump impeller and pump impeller is plug fouling pay next time you start to burn and cause motor failure.